Material

All Unit Holds are made out of polyurethane (PU) resin. Polyurethane doesn’t chip as easily or break when tightened. And it’s a lot lighter than Polyester resin holds.

Hollowback

At Unit Holds we believe that lighter is better. Therefore, when its possible to make a Hollowback, we do it. Next to making it a lot lighter it also reduces the amount of material needed. Where needed our holds are enforced with extra ribs in the hollowback to ensure stability when put under pressure.

ATTACHMENT

No bolts? Screw it! We believe in freedom for the setters. Therefore most of the Unit Holds are screw-on. Only when screw-on was not an option we added a bolt to the hold. 

All screw holes are reinforced with stainless steel metal washers. Our bolt-on holds are equipped with dual bolt inserts that accept both cap-head and countersunk bolts. All of the bolt-on holds also include an additional screw hole to prevent spinning of the hold.

VOLUMES

All Unit Volumes are made of fiberglass and polyester resin. The fiberglass makes for a strong but light volume. All volumes have a flange to increase stability of the shape. The fiberglass volumes are covered with a strong coating with sand that ensure for a long lasting grippy feel.

Colors

At Unit Holds we provide a wide range of colors. We use the same colors for both our holds as for our volumes. This makes for a uniform look when  combining the volumes and holds. 

Didn´t find the color of your liking? Send us a mail and we will see what we can do for you. 

STANDARD COLORS

LUMINOUS COLORS